TV Fool  

Go Back   TV Fool > Over The Air Services > Help With Reception

Notices

Reply
 
Thread Tools
Old 13-Jan-2019, 1:46 PM   #1
blackstone
Senior Member
 
Join Date: May 2017
Posts: 139
Lost all VHF stations

I was happily getting all the stations that were available to me on VHF and UHF until a week and a half ago.

I received a lot of great patient help here in this thread a couple years ago.
http://forum.tvfool.com/showthread.php?t=16358

Forgive the long post and hope you will help me again.
Thanks, in advance.

About 10 days ago we had some pretty high winds that spun my CM VHF antenna around and pulled the cable out of it's connector.
After several failed attempts to put on a new end, I bought a new 50' cable.

There was still a section of cable I couldn't reach because the connections were too high above my roof line to reach and it's a bit of a chore to drop the antenna and raise it again.

I got a new antenna from Antennas Direct; a ClearStream 5.
Moved it away from the metal roof and it's 16'-18' high.

It's pointed around 220.

Before, I got the following VHF stations:
WPCW 11 (RF) 19 Virtual
WTOV 9 9
WQED 13 13
WWCP 8 8

After I only get WWCP.
I shouldn't get this because it's in a way different direction.

I got a Klein continuity tester.
Connected to the coax that runs to the antenna,
It reads "Open"

Not sure what that means or how to fix the problem.

The cable is connected to the balun on one end and a pre-amp on the other
blackstone is offline   Reply With Quote
Old 13-Jan-2019, 3:43 PM   #2
Nascarken
Banned
 
Join Date: Jun 2016
Posts: 346
So what kind of ANTENNA were you using before the antenna Direct?
If you were using a Winegrud 8200U the best ANTENNA for the money
but it sounds like you will have to get a new balun
For it that is what happens to them that is why you have lots
your vhf channels GO to solied SIGNAL.com for a new balun
Cost is like $20dollars+shipping

Last edited by Nascarken; 13-Jan-2019 at 4:00 PM.
Nascarken is offline   Reply With Quote
Old 13-Jan-2019, 7:54 PM   #3
blackstone
Senior Member
 
Join Date: May 2017
Posts: 139
Thanks for your response, Nascarken.

I was using a Channel Master directional antenna; about 30 years old.
Since I didn't know if these things deteriorate, I bought the ClearStream.

I discovered that Antennas Direct is open 7 days and was able to contact them.

The first rep said to get a new coax to replace the new coax.
After doing that, I still had an open circuit.

The second rep diagnosed a bad balun, too, and they are sending one out at no charge.

One of the other things that puzzled me is why I'm getting WWCP 8.
Even now with the VHF completely disconnected.

I'm guessing that I get it through their UHF channel 23 even though it shows up on 8 when I scan
blackstone is offline   Reply With Quote
Old 14-Jan-2019, 2:38 PM   #4
Nascarken
Banned
 
Join Date: Jun 2016
Posts: 346
Yes that's true and why is that it's becuse of your amp will some time's pull in vhf channels.And antnnas Direct is good when it comes to their antennas they stand behind
their products
Nascarken is offline   Reply With Quote
Old 14-Jan-2019, 6:53 PM   #5
blackstone
Senior Member
 
Join Date: May 2017
Posts: 139
Thanks Nascarken
blackstone is offline   Reply With Quote
Old 29-Mar-2019, 2:35 PM   #6
blackstone
Senior Member
 
Join Date: May 2017
Posts: 139
Rather than start a new thread, I thought I'd resurrect this one because it is still related.

Thanks, in advance, for your suggestions.

After replacing the balun, I still wasn't able to get much reception.

I figured out that my Channel Master amp went bad.
Upon replacement, I got lots of stations again.
For a short while, that is.

I have lost all but one of my VHF stations and can't get them back.
The stations I have lost are:
WPCW 19 which was one of my strongest stations. I was able to get that, almost, with the antenna on the ground. Now, it is very weak and pixelated.

WTOV 9. This one was a long ways off but came in real well. Nothing now.

WQED 13. This wasn't a terribly strong station but it usually came in.

(I have, also, lost WPGH 53 (virtual) and this is the only UHF station I can't get.)

It is my understanding that WQED has moved to low on the VHF band and reduced power.
I was told that WPGH has also moved down to real channel 20.

Right now, the Clear Stream gets WWCO 8 because I pointed it there to get a Fox channel and it's strong.

I have tried from 180 to 245 degrees trying to pick up some of the lost stations but nothing.

I have about one week to decide to return the Clear Stream to Antennas Direct and go back to a directional antenna.

Any thoughts are appreciated.
blackstone is offline   Reply With Quote
Old 29-Mar-2019, 4:14 PM   #7
Nascarken
Banned
 
Join Date: Jun 2016
Posts: 346
Quote:
Originally Posted by blackstone View Post
Rather than start a new thread, I thought I'd resurrect this one because it is still related.

Thanks, in advance, for your suggestions.

After replacing the balun, I still wasn't able to get much reception.

I figured out that my Channel Master amp went bad.
Upon replacement, I got lots of stations again.
For a short while, that is.

I have lost all but one of my VHF stations and can't get them back.
The stations I have lost are:
WPCW 19 which was one of my strongest stations. I was able to get that, almost, with the antenna on the ground. Now, it is very weak and pixelated.

WTOV 9. This one was a long ways off but came in real well. Nothing now.

WQED 13. This wasn't a terribly strong station but it usually came in.

(I have, also, lost WPGH 53 (virtual) and this is the only UHF station I can't get.)

It is my understanding that WQED has moved to low on the VHF band and reduced power.
I was told that WPGH has also moved down to real channel 20.

Right now, the Clear Stream gets WWCO 8 because I pointed it there to get a Fox channel and it's strong.

I have tried from 180 to 245 degrees trying to pick up some of the lost stations but nothing.

I have about one week to decide to return the Clear Stream to Antennas Direct and go back to a directional antenna.

Any thoughts are appreciated.
For what you payed yes you should .
Nascarken is offline   Reply With Quote
Old 29-Mar-2019, 4:18 PM   #8
ADTech
Antennas Direct Tech Supp
 
Join Date: Jan 2010
Posts: 2,942
Please contact our customer tech support directly for assistance, the contact form link is in my signature below.
__________________
Antennas Direct Tech Support

For support and recommendations regarding our products, please contact us directly at https://www.antennasdirect.com/customer-service.html

Sorry, I'm not a mod and cannot assist with your site registration.
ADTech is offline   Reply With Quote
Old 29-Mar-2019, 5:32 PM   #9
blackstone
Senior Member
 
Join Date: May 2017
Posts: 139
ADTech, I have been in touch with customer support.
I forgot to mention that.

Their solution was to point my Clear Stream at WWCP 8 to get Fox. I did that

No suggestions on how to get the CW, forget about WQED and maybe raising or lowering my UHF may get channel 53 back.
blackstone is offline   Reply With Quote
Old 30-Mar-2019, 8:17 AM   #10
blackstone
Senior Member
 
Join Date: May 2017
Posts: 139
By the way, I'm not knocking Antennas Direct.

I happen to think they're a company with integrity.

I'm just trying to get the same stations I got recently that have disappeared
blackstone is offline   Reply With Quote
Old 30-Mar-2019, 1:08 PM   #11
JoeAZ
Senior Member
 
Join Date: Mar 2017
Posts: 413
You may just be encountering the repack in your area.
I suggest you rescan and see if any of those stations
come in again.
JoeAZ is offline   Reply With Quote
Old 30-Mar-2019, 1:20 PM   #12
Nascarken
Banned
 
Join Date: Jun 2016
Posts: 346
Yes fcc suggests that you rescan all TV do too the repacking of BROADCASTING channel's
And you might have to bring your antenna up 10ft more and did you get a new channels master amp!!
Nascarken is offline   Reply With Quote
Old 30-Mar-2019, 2:00 PM   #13
blackstone
Senior Member
 
Join Date: May 2017
Posts: 139
Thanks for the suggestions.

I rescan (almost) daily with no effect.

Antennas Direct support said that one station, WPGH 53, moved from real 43 to 20.
I think they said that it would improve the signal through the hills but decrease it through the trees (or something like that.)

WQED 13 moved from real 13 to 2 and cut their power.
The tech said I might need a low VHF directional antenna.

The other two stations are a mystery.

I was looking at replacing my Clear Stream 5 with something like a Channel Master 3020 or 5020.

I can't determine if the 3020 is a low VHF antenna or not.

Also, looking for the reception angle for the 3020.
Supposedly the 5020 is this:

Reception angles:
VHF L (channels 2-6, and FM) 63 degrees
VHF H (channels 7-13) 34 degrees
UHF 39 degrees
blackstone is offline   Reply With Quote
Old 30-Mar-2019, 8:52 PM   #14
Nascarken
Banned
 
Join Date: Jun 2016
Posts: 346
Yes sounds like the channel master is a good pick.
Nascarken is offline   Reply With Quote
Old 30-Mar-2019, 9:00 PM   #15
blackstone
Senior Member
 
Join Date: May 2017
Posts: 139
I ended up doing a return on the Clear Stream and ordered a CM 5020.
Several things were factors in the decision to go with this one.
The weight and size are a little smaller so I'm hoping it will handle winds a little better on the mast.
Reception angles and it states low VHF.

If Antenna Direct had a VHF antenna like that, I would have, probably, gone with them again because I think they are a decent company
blackstone is offline   Reply With Quote
Old 30-Mar-2019, 9:25 PM   #16
Nascarken
Banned
 
Join Date: Jun 2016
Posts: 346
Quote:
Originally Posted by blackstone View Post
I ended up doing a return on the Clear Stream and ordered a CM 5020.
Several things were factors in the decision to go with this one.
The weight and size are a little smaller so I'm hoping it will handle winds a little better on the mast.
Reception angles and it states low VHF.

If Antenna Direct had a VHF antenna like that, I would have, probably, gone with them again because I think they are a decent company
You should have went with the 3020,IT'S better for the low vhf.&
Suggest you should use a channel master 7778AMP
We'll good luck let us know what happens with it when you install it.
Nascarken is offline   Reply With Quote
Old 30-Mar-2019, 9:34 PM   #17
blackstone
Senior Member
 
Join Date: May 2017
Posts: 139
The 3020 was cheaper, too.
If I could have found info that stated low VHF, I may have gone that route.

I do have a channel master amp that's only a month old and a pretty new pre-amp.

Looks to be about a week for the new antenna to be ready for pick up.
I'll be back
blackstone is offline   Reply With Quote
Old 30-Mar-2019, 9:50 PM   #18
Nascarken
Banned
 
Join Date: Jun 2016
Posts: 346
Quote:
Originally Posted by blackstone View Post
The 3020 was cheaper, too.
If I could have found info that stated low VHF, I may have gone that route.

I do have a channel master amp that's only a month old and a pretty new pre-amp.

Looks to be about a week for the new antenna to be ready for pick up.
I'll be back
You should have looked at SOLiD single.com
and I didn't know if you had an amplifier
So how hi up are you going with the channel master.
But I think you should have went with the 3020.
I think it's more of what you are looking for.
The 5020 is more hi band vhf,than low the 5020
Came out when the hi vh f Took off
The 3020 has a better RECEIVE on low band vhf.
Go to SOLiD single.com and check it out.
Nascarken is offline   Reply With Quote
Old 30-Mar-2019, 9:56 PM   #19
blackstone
Senior Member
 
Join Date: May 2017
Posts: 139
Thanks for that info, nascarken.

The antenna is, probably, going up 16'-18'.
I may have understood what you meant by the amp.
I have a CM amp/splitter in my basement.
I'd have to check the model

What is the link you are sending me to?
I looked at solidsingle dot com and that isn't valid

Last edited by blackstone; 30-Mar-2019 at 9:59 PM. Reason: Additional
blackstone is offline   Reply With Quote
Old 30-Mar-2019, 10:56 PM   #20
Nascarken
Banned
 
Join Date: Jun 2016
Posts: 346
Quote:
Originally Posted by blackstone View Post
Thanks for that info, nascarken.

The antenna is, probably, going up 16'-18'.
I may have understood what you meant by the amp.
I have a CM amp/splitter in my basement.
I'd have to check the model

What is the link you are sending me to?
I looked at solidsingle dot com and that isn't valid
Two word's SOLiD single.com
Nascarken is offline   Reply With Quote
Reply

Bookmarks

Go Back   TV Fool > Over The Air Services > Help With Reception


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off




All times are GMT. The time now is 10:45 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © TV Fool, LLC