[bob.gibson@att.net]

I have two digital antennas pointed in different directions and would like to converge both signals through a Channel Master CM-3412 2-port signal amplifier and into my DVR. I'm just not sure what coaxes go where. I have the power going into the amp at "PWR IN, 12-16 VDC", a coax going from the amp to the DVR "RF OUT, 11 dB", and the two antenna coaxes entering into the amp at "PWR IN, RF OUT 11dB" and "RF IN, REV OUT, 4dB". The signals appear to be fine, but is it configured correctly? Do I possibly require a 4-pole amp?