Antennae suggestions
 

Years ago I asked for help with finding and antennae for my area. Now that I have finally had it with Direct TV. I am once again asking for help. Is there an antennae out there that I can install in my attic? I want to avoid installing it outside on the roof as the wind out here is horrible. It was suggested here on my previous thread that i should put up two antennae's for different signals. Can this be avoided? If not, can I put the two in the attic? Thanks for all your help.

http://www.tvfool.com/?option=com_wr...0559ec8041a379

Based on the tvfool report being resolved to the block level only , and the default 10 feet antenna height above ground.

Above the Peak Of The Roof in such a manner that the roof and house do not impede or block reception to the , north east , south west.

Install and aim a Winegard HD7698P antenna at about 76 degree magnetic compass direction , north east.

WWTO channel 10 to the south west , is strong signal strength and will be received through the back angle of the HD7698P antenna.

So only 1 HD7698P antenna is required for reception.

Here is how to aim antennas , http://www.kyes.com/antenna/pointing/pointing.html.

Here are some strong and sturdy above the roof antenna mounts.

http://www.ronard.com/909911.html. Use the 5 foot , ronard (911) , tripod antenna mount.

http://www.ronard.com/34424560.html. Use the , ronard (4560) , eave antenna mount.

http://www.ronard.com/ychim.html. Measure the chimney and use. ronard (2212) , or , ronard (2218) , or , ronard (2224) .

Buy the ronard antenna mounts at solidsignal by typing , ronard (x) in the the solidsignal search box or buy from ronard.

Here are some places to by antennas and etc. .

http://www.solidsignal.com.

http://www.amazon.com.

http://www.winegarddirect.com.

______________

Install a Winegard HDP-269 preamp.

______________

For 1 tv connected use No splitter.

For 2 Tv's connected use a , HFS-2D , 2 way splitter.

For 3 Tv's connected use a HFS-3D , 3 way splitter.

Buy the HFS splitters at , http://www.solidsignal.com or http://www.hollandelectronics.com.

______________________________________

Disconnect and Remove All passive and active satellite system componets such as and not limited to , multi-switches , multi-plexers , combiners , splitters , amplifiers , power injectors , powers supplies and etc. .

Yes the satellite system coaxes and other coaxes can be used for the Broadcast Tv antenna system.