TV Fool  

Go Back   TV Fool > Over The Air Services > Help With Reception

Notices

Reply
 
Thread Tools
Old 26-Feb-2018, 11:37 PM   #1
jukes
Junior Member
 
Join Date: Nov 2017
Posts: 1
VHF high troubleshooting

I'm trying to receive NBC on 8.1 from a tower about 4 miles away. It's a 2 edge path, and there's another tower about 1/2 mile from me basically in the same direction... it doesn't have anything VHF on it but it could have tons of other stuff.

http://www.tvfool.com/?option=com_wr...9038cd6362cc32

I have an RCA ANT751R on the roof, running through a TVPRAMP1Z with the FM filter turned on. I have an additional FM filter after the amp, and that terminates in an HD Homerun 5.

Some days, I get 8.1 completely fine, and other days I can't even decode a signal on that band. It's not completely weather dependent, but seems worse when there is moisture in the air. Wind matters somewhat... on windy days I never get NBC, but it can be dead still like today and I don't have anything.

I have been thinking of adding an antenna that is specific for VHF high to see if that helps, but I'm worried that the problem is related to multipath interference and not signal strength. Does anyone know of good resources to continue to try and figure out what's going on on this one band in Portland?
Attached Images
File Type: png Untitled.png (181.9 KB, 599 views)
jukes is offline   Reply With Quote
Old 27-Feb-2018, 11:13 AM   #2
ADTech
Antennas Direct Tech Supp
 
Join Date: Jan 2010
Posts: 2,942
Move the external FM filter so it's before the amplifier. It does little to no good after the amp. The internal filter in your amp is ineffective at the low end of the FM band and it's the low end of the FM band (90-93 MHz) that has the greatest potential to cause 2nd harmonic interference into channel 8's bandwidth.

I have no idea if this will solve your particular issue, but its a glaring error in the connection scheme. I always recommend fixing the obvious first to get those issues off the table.
__________________
Antennas Direct Tech Support

For support and recommendations regarding our products, please contact us directly at https://www.antennasdirect.com/customer-service.html

Sorry, I'm not a mod and cannot assist with your site registration.
ADTech is offline   Reply With Quote
Old 27-Feb-2018, 6:25 PM   #3
Tower Guy
Senior Member
 
Join Date: Dec 2009
Location: Delmar, NY
Posts: 1,236
EGADS. There are 11 FM stations on that tower .5 miles away. Some are 97KW ERP. In addition to ADTechs suggestion of moving the FM filter, you may want to try only the filter and no preamp.
Tower Guy is offline   Reply With Quote
Old 28-Feb-2018, 2:17 AM   #4
rabbit73
Retired A/V Tech
 
Join Date: Aug 2012
Location: S.E. VA
Posts: 2,747
Good advice from ADTech and Tower Guy.

Your FM signal report; the second strongest FM signal report I have ever seen:

http://www.fmfool.com/modeling/tmp/3...5/Radar-FM.png



Very likely to cause interference to TV reception.

You must ground the coax with a grounding block connected to the house electrical system ground to make the FM filter (or two FM filters in series) effective.

If the antenna is outside, the coax shield should be grounded with a grounding block that is connected to the house electrical system ground with 10 gauge copper wire for electrical safety and to reject interference. For further compliance with the electrical code (NEC), the mast should also be grounded in a similar manner to drain any buildup of static charge which will tend to discourage a strike, but the system will not survive a direct strike.



Unfortunately, FM filters are no longer in stock at Antennas Direct. I hope they will reconsider their decision not to carry them anymore; they were the last remaining regular supplier of FM filters.

https://www.antennasdirect.com/store...on_filter.html

It is now necessary to scrape the bottom of the barrel, or use a HLSJ, high and line ports, that is also hard to find.

https://www.solidsignal.com/pview.asp?p=zhlsj
Attached Images
File Type: jpg jukesTVF FM.JPG (117.9 KB, 999 views)
__________________
If you can not measure it, you can not improve it.
Lord Kelvin, 1883
http://www.megalithia.com/elect/aeri...ttpoorman.html

Last edited by rabbit73; 28-Feb-2018 at 3:30 AM.
rabbit73 is offline   Reply With Quote
Reply

Bookmarks

Tags
vhf high

Go Back   TV Fool > Over The Air Services > Help With Reception


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off




All times are GMT. The time now is 3:08 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © TV Fool, LLC