View Single Post
Old 8-Feb-2017, 2:25 AM   #2
rabbit73
Retired A/V Tech
 
Join Date: Aug 2012
Location: S.E. VA
Posts: 2,352
First choice: compression; most waterproof, but you must get the right size for YOUR RG6
Second choice: crimp, hex shape; it's what I use
Third choice: twist on; forget it, it falls off

Test the coax with your ohmmeter for shorts between center conductor and shield, with nothing else connected to it

Test the shield for continuity

Test the center conductor for continuity

If the ohmmeter leads can't reach both ends, short the far end and check for continuity at the near end (round trip)

The 50 ohm CB SWR bridge will not be useful for your 75 ohm OTA RG6 coax

Don't bend the coax into too small a radius; the center conductor can migrate through the foam dielectric and short to the shield.

Don't over tighten the connector; you can break the female jack off its circuit board.
__________________
If you can not measure it, you can not improve it.
Lord Kelvin, 1883
http://www.megalithia.com/elect/aeri...ttpoorman.html

Last edited by rabbit73; 8-Feb-2017 at 2:33 AM.
rabbit73 is offline   Reply With Quote