Thread: IN or OUT?
View Single Post
Old 18-Apr-2011, 2:08 AM   #1
m-323
Junior Member
 
Join Date: Apr 2011
Posts: 4
Arrow IN or OUT?

hi folks.

I made up an antenna mast, 30ft of aluminum tube (which is mounted 5ft above my deck) right now the cable is inside the the aluminum tube.

the guy I bought the antennas from says the cable should be outside because the aluminum may cause RF signal to bounce around inside the tube causing interference.

I thought it was better inside for less wind resistance and to protect the cable.

at the top of the mast are two 8 bay channel masters pointing in different directions. right now they are one under the other but I intend to move the lower one down about 15 inches from the other (on advise from the retailer again)



so my questions are;

1) would you put the cable in the mast or outside?

2) are the antennas ok to be right under one another or would 15' between them make any difference?

I was thinking max height should be the goal?

and

3) is a smaller directional antenna better than the square 8 bay channel masters?



thanks for your help.

Last edited by m-323; 18-Apr-2011 at 2:17 AM.
m-323 is offline   Reply With Quote