Quote:
Originally Posted by tripelo
Good morning Sev.
The CM 0064DSB has a regular ferrite 300:75 Ohm balun at its input.
The core and windings are seen in the lower right of this image (near input terminals).
Could be CM used a slightly better core than used in most commercial baluns. However, the balun has loss.
Removed the core and windings, replaced with half-wave loop saw signal about 1-2 dB strength improvement.
.
No offense Sev, the post was quick and for a while was thinking about Bob's earlier posts.
|
No offense at all. More information is always better.
By the by. Perhaps you would know. As anybody ever added the missing components on that board to switch it to a 0264?
Would have have a picture of the 0264 board? I have yet to come across one.