5-way splitter
Firstly, here's my report:
http://www.tvfool.com/?option=com_wr...46ae9ed2a16afb I live in a very heavily wooded area, where the trees are over 100 feet tall. I tried a Mohu Leaf ultimate antenna, in the room above my garage, and if I turned towards the south, I got the Boston channels, intermittently, but I returned it. I'll be happy if I can get the networks. My plan is to get a rooftop antenna, facing 171 degrees, to get WCVB, WGBH, WBZ, WHDH, and WFXT, which are all about 35 miles away. I was thinking of either the DB2E or ClearStream2, which have 45-50 mile ranges, or the DB4E or ClearStream4, with 65+ ranges. I was hoping as a bonus that I could pick up WMUR which is 14 miles in almost the exact opposite direction, since the antennas advertise that they can pick up high VHF. I have 5 zones to split the signal to. I was going to use the cable splitter that I still have from Comcast (I cut the cord last month), but I need to know if I'll need a pre-amp, and which antenna I should choose, and if I should get a different splitter, that can inject power to the pre-amp. Thanks for any help |
If you're in that heavily wooded of an area, anything you get is going to be potluck.
Try whatever antenna on a single set with a direct connection. If it works, then an 8 port distribution amp would likely work well. |
I'd suggest you start with an Antennas Direct DB4e. If you are happy with the results, consider adding an Antennacraft Y10713 for support of real CH-9 & CH-11.
The trees can be a challenge. |
Aim a Channel Master CM4228HD antenna at about 192 degree magnetic compass direction.
Here is how to aim antennas , http://www.kyes.com/antenna/pointing/pointing.html. Use a Old School magnetic compass. ___________________ Install a Channel Master CM7778 preamplifier. ___________________ Install the preamp power supply and power injector and preamp unit between the splitter and antenna and or use a splitter that passes power through one or more input/output ports. |
Distribution Amp
Were you talking about something like this: http://www.amazon.com/8-Port-Bi-Dire.../dp/B000WDR94U for the 8-port distribution amp? Do you think an amp will be necessary? I was just going to open the Comcast box, on the outside of my house, and connect the antenna's cable to the "input" on the splitter that is already there, since the cables already run into the house, to my TVs.
Although there are a LOT of trees, they are probably in the 75-80 foot range. Most are the huge pines that I call "telephone poles", because they are tall, straight, and have almost no branches on the bottom 3/4 of the tree. They just have a "cap" at the top. Anyway, they might be what was causing the intermittent signal with the Mohu. What is the difference between the DB4e and the ClearStream4? Thanks for the help. |
The CM4228HD has good reviews, but the listed dimensions are 9 1/2 by 8 feet! That is WAY too big. My wife would have a cow if I put that up on our roof! The DB4e is listed at 2 by 3 feet, which is a lot easier to justify, and it also has 4.5 star average review and many recommendations. My only other question is whether to get the 40 inch or the 30 inch J-mount, to go with it.
Does anyone think I'll need both a pre-amp and a distribution amplifier, or just one of them. I was reading this article: http://www.dennysantennaservice.com/...mplifiers.html and wondering if the signals are considered strong or weak. The article says with a weak signal and a 6 or 8 way splitter, to go with both a pre-amp and a distribution amp. With a strong signal, it says to only use the distribution amp. The Boston stations are listed between 20-32 NM(dB) on my TVFool signal analysis, but there are some closer stations that go up to 53.4. I don't want to overdrive those signals. Actually the only one I would watch is the WMUR, which is listed at 52NM, and is high VHF. If I go with the DB4e and a 6-way splitter, would I need both amplifiers? I could use some recommendations on a splitter, as well as amplifiers. Thanks, again. |
I think I'm close
I just read the ENTIRE dscription of the CM4228HD on Amazon.com. In the "product features" section, it lists the dimensions as: 113 x 95 x 22 inches. In the "technical details" section, it lists the dimensions as: 41.2 x 3 x 34.5 inches, which is more believable.
Having said that...it costs over $100, so I investigated the Terrestrial Digital DB8, which is a sub-brand of Antennas Direct, and is listed at $79. This one got great reviews, and was also the recommended antenna, when I put my address into HDTV Antenna Labs, as the single antenna solution. That site also said that a pre-amp was required. I think I'm going with this antenna, and I'm leaning towards the CM7777 pre-amp and the PCT International 8-port amplifier/splitter. If anyone can see potential problems with this set-up, please chime in, as I'll probably make the purchase later today. I want to get this set up, in time for NFL on Sunday! |
Quote:
Quote:
Quote:
Quote:
Quote:
Quote:
|
Thank you
Quote:
Quote:
Quote:
Quote:
Quote:
Thank you very much for your advice...I'm really looking forward to getting it all set up! |
All times are GMT. The time now is 4:17 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright © TV Fool, LLC